CELEBRATING 130 YEARS NEW & SPECIALTY PRODUCTS PRODUCT LIST INTERACTIVE CATALOG CALCULATORS SUPPORT PRODUCT LITERATURE REQUEST INFO Ross Valve 
Search Catalog
      GO   
 All Categories    Valves for Treated Water
All Categories > Valves for Treated Water 
 

Valves for Treated Water

 
Click on a category to drill down.

Request Information
Schematic-Pressure-Reducing

Pressure Reducing Valves

Maintains constant downstream pressure regardless of fluctuations in upstream pressure or flow.

Schematic-Altitude

Altitude / Level Control Valves

Prevent overflow of a tank/basin via hydraulic pilot, electric solenoids, or float device.

Schematic-Pump-Control

Pump Control Valves

Minimizes start/stop surges associated with pump operation.

Schematic-Back-Pressure

Back Pressure Sustaining Valves

Prevents upstream pressure from falling below a predetermined setting.

Schematic-Relief

Pressure Relief / Surge Control Valves

Protect a line from excessive pressures and water hammer (with available surge anticipation feature).

Schematic-Flow-Control

Rate of Flow Control Valves

Maintains a constant flow rate in a line.

Schematic-Check

Check Valves

Prevents reverse flow in a line.

Schematic-Safety

Safety Valves

Automatically open or close in a variety of emergency conditions.

Schematic-Electrically-Operated

Electrically Operated Valves

Use an electric signal to open, close or throttle the valve.

Schematic-Energy-Dissipating

Extreme Service Valves

Safely control pressure or flow in extreme conditions.

Schematic-Diaphragm

Diaphragm Style Valves

Available in most configurations listed above. Generally considered for short term use. Please consult factory.
Years of experience have shown that our rigid red brass control piping (minimum 1/2 inch diameter) can stand up to the decades of service expected of our valves.A visual position indicator gives an accurate assessment of valve position, which is invaluable in monitoring valve performance and troubleshooting.Our standard strainer to protect the controls from contaminants is actually functional - with over 7 square inches of surface area.Due to the long stroke inherent to our piston style design, we can optimize each valve's performance by tailoring the seat contour design to the valve's specified application.Each valve is built standard with ANSI Class 250 construction with regard to wall thickness, internal components, and controls. Flanges are sized and drilled as specified to mate with adjacent pipes and equipment.All ferrous surfaces are coated with two layers of NSF Certified Epoxy Coating inside and out.The rugged bottom cylinder ensures that the valve piston is fully guided above and below the seat to counter any lateral forces and ensure correct alignment at the seat.All control devices are built to meet our strict requirements for durability, to ensure a long service life of the entire valve assembly.Though every valve is tested at the factory prior to shipment, devices like the speed control valve may be adjusted in the field for further refinement, should operating conditions change.The Ross Piston Style design utilizes rugged seals that wear gradually and are not vulnerable to sudden failure or rupturing.Ross Valve | Automatic Control Valves for the Water and Wastewater Industries