CELEBRATING 130 YEARS NEW & SPECIALTY PRODUCTS PRODUCT LIST INTERACTIVE CATALOG CALCULATORS SUPPORT PRODUCT LITERATURE REQUEST INFO Ross Valve 
Search Catalog
      GO   
All Categories  
 

All Categories

 
Click on a category to drill down.

Request Information
Valves-for-Treated-Water

Valves for Treated Water


Automatic control valves designed for use with treated water. Available in a wide variety of configurations to control pressure, level, flow, pumping, water hammer, etc.

Valves-for-Untreated-Water

Valves for Untreated Water


Automatic pump control and pressure control valves for raw/untreated and wastewater applications.

Valves-for-Extreme-Service

Valves for Extreme Service


Specialty valves ideal for installations with extreme pressure drops and/or flow conditions.

PrePackaged-Vaults

Pre-Packaged Vaults


Take advantage of our experience and expertise with a pre-engineered and pre-assembled vault. We design, engineer, and build to your requirements, then install the pre-tested vault on the jobsite.

Fire-Fighting-Valves-B

Fire Fighting Valves


Small pressure control valves specifically designed for installation on fire trucks and hydrants.

Strainers

Strainers


A variety of large and small strainers with the same rugged construction and durability as our valves.
Years of experience have shown that our rigid red brass control piping (minimum 1/2 inch diameter) can stand up to the decades of service expected of our valves.A visual position indicator gives an accurate assessment of valve position, which is invaluable in monitoring valve performance and troubleshooting.Our standard strainer to protect the controls from contaminants is actually functional - with over 7 square inches of surface area.Due to the long stroke inherent to our piston style design, we can optimize each valve's performance by tailoring the seat contour design to the valve's specified application.Each valve is built standard with ANSI Class 250 construction with regard to wall thickness, internal components, and controls. Flanges are sized and drilled as specified to mate with adjacent pipes and equipment.All ferrous surfaces are coated with two layers of NSF Certified Epoxy Coating inside and out.The rugged bottom cylinder ensures that the valve piston is fully guided above and below the seat to counter any lateral forces and ensure correct alignment at the seat.All control devices are built to meet our strict requirements for durability, to ensure a long service life of the entire valve assembly.Though every valve is tested at the factory prior to shipment, devices like the speed control valve may be adjusted in the field for further refinement, should operating conditions change.The Ross Piston Style design utilizes rugged seals that wear gradually and are not vulnerable to sudden failure or rupturing.Ross Valve | Automatic Control Valves for the Water and Wastewater Industries